Show Your DIY Disney Side: Disney Parks Guide Map Coasters

I’ve got another “Show Your DIY Disney Side” craft to share with you today, with step-by-step instructions for turning your Disneyland Resort guide maps and tickets into handmade keepsakes. Not much of a crafter? No need to fear! These projects are quick, easy and fun to make. All it takes is a little faith, trust and pixie dust (and a few supplies from the art supply store)!

Show Your DIY Disney Side: Disney Parks Guide Map Coasters Show Your DIY Disney Side: Disney Parks Guide Map Coasters

Today, we’re making a set of drink coasters using Disneyland and Disney California Adventure park guide maps, tickets and the most important piece, bathroom tiles. But don’t start ripping your bathroom apart just yet! Home improvement stores sell individual ceramic tiles, and some cost less than a quarter each.

DSC706953

Whether you’re giving these coasters as a gift or keeping them for yourself, they’re sure to add a magical touch to any table. I’ll chEARS to that!

Supplies:

  • Square ceramic tiles (Mine were 4 ½” x 4 ½”.)
  • Disneyland Resort guide map, theme park tickets or any other decorative paper, cut into 4” squares
  • Foam brush
  • All-in-one decoupage glue, sealer and finish
  • Waterproof acrylic sealer
  • Thin cork, cut into 4” squares
  • Heavy-duty crafting glue

DSC706954

Step 1: Wipe the tile with a damp cloth to remove smudges and fingerprints.

DSC706955

Step 2: Use the foam brush to paint the tile with a generous coat of decoupage glue. Immediately center paper on the tile, pressing firmly on one edge and working your way to the opposite end to get rid of air bubbles and creases. Allow to dry for 10-15 minutes.

Tip: Be sure to apply additional pressure to the edges and corners since they’re prone to peeling.

DSC706956

Step 3: Brush a layer of decoupage glue over the paper and tile, making sure your brushstrokes run in one direction (You’ll be able to see the strokes when the glue dries). Allow to dry for 10-15 minutes.

Step 4: Brush a second layer of decoupage glue over the paper and tile in the same direction as in Step 3 or in the opposite direction to create a crosshatch pattern. Allow to dry for 10-15 minutes. Repeat steps 3 and 4 until the desired look is achieved. (I used four layers of decoupage glue.)

Step 5: Apply a thin layer of acrylic sealer according to the sealer directions. Allow to dry completely.

DSC706957

Step 6: Use crafting glue to attach a cork square to the back of the tile. (That way, you can use and stack your coasters without worrying about scratches.)

Repeat process with remaining tiles. Allow each to dry for at least 24 hours before use.

Which DIY Disney Side craft are you working on? Tell us in the comments!

Show Your DIY Disney Side: Disney Parks Guide Map Coasters by Erin Glover: Originally posted on the Disney Parks Blog


Disney Parks Blog

Leave a Reply